This is my ripper that I made from scratch and am in the process of adding 2 more shanks to it. I started with 2 shanks and have found 2 more so I will add them. so far I have 1 levt to put on. I used 1/4" thick angle iron that is 4"x4" for the framework and doubled it in places. this ripper goes 24" deep and takes big power to pull it.




thanks; sonny

Uff....what are planning to pull this with. I got a single tooth subsoiler I pull with an 8n and works surprisingly well.

Dads 730 Deere pulled it fine with 2 shanks,----- The 560 did pull at it,---not heavy enough in the ass end. I was going to run it behind the AC 440 4x4 tractors.

the IH 250 trackloader would pull it..put that old beast to work Sonny..air it out

Ya, ---- it would be an insult to the 250! It wouldnt even know it was back there! LOL!