Stripped down Deere front end.

BTW you can only link 10 pics at a time in one post.

[Linked Image from live.staticflickr.com]

The engine on the Deere is a 3TNV84T 39HP turbo. The Jacobson had a Kubota V2203 which is 49 hp. I am using the John deere hydraulics so hopefully engine will handle the loads. The cutting hydraulics for the Deere have adjustable flow so if it is too much power at full flow I can turn them down some. Not sure if that would reduce hp input from the engine. Probably not because the pump would still be making the same flow and pressure, At least I could adjust the speed some if needed.

Last edited by GatorS; 05/18/2020 12:42 AM.
Machine Builders Facebook Page
https://www.facebook.com/groups/1153014311474457/

Report site issues on the FB page if you can't on the main site.