I got the hydraulic unit and all the hoses in last week. I got it wired in Thursday afternoon and did a couple lifts, both sides lifted to the top, but it didn't take me long to figure out that the cylinder on the right side had a leak in the packing. It was squirting pretty good. I was able to manually push the cylinder back down, leaving the carriage pinned up. I dropped it off friday at the local cylinder repair place. The cables should come in tomorrow, and hopefully they will get the cylinder done also. I will get it all assembled and test it out.

Anybody guess why this towel is tied on there.........

[Linked Image from live.staticflickr.com]

Machine Builders Facebook Page
https://www.facebook.com/groups/1153014311474457/

Report site issues on the FB page if you can't on the main site.