|
1 members (bunkclimber),
19
guests, and
26
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums23
Topics355
Posts4,521
Members404
|
Most Online248 Mar 14th, 2020
|
|
S |
M |
T |
W |
T |
F |
S |
|
|
|
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
31
|
|
|
|
Joined: Jan 2019
Posts: 1,409 Likes: 11
MBN veteran
|
OP
MBN veteran
Joined: Jan 2019
Posts: 1,409 Likes: 11 |
Right now the track split is the only problem I have on this one They claim you can drive them out--- BUT these wont! --- 16 pound sledge hammer full swing with strong guy---me holding the big bar and no go! --- dont want to break the drive sprocket either. Heat didnt do the job. --- bigger torch? didnt wand to have to make a pin press ----- guess that is always an option if all else fails. Nick suggested cutting thru the pin boss with cutoff grinder then after the pin is put back in--- weld the gap shut ---- he says they do that on small crawlers and have good luck with it. Another problem we have is figuring which way is out on these --- looks to me like one track rail was put on backwards at some point.
How much pressure would 1 inch all thread rod hold if that was used for press frame? --- not a lot of room for big stuff in there. Always open to ideas!
"A machine you build yourself is a vote for a different way of life. There are things you have to earn with your hands."
|
|
|
There are no members with birthdays on this day. |
|
|
|
|