Im building a new welding table, need more fab space and this will do it..a 4ft x 5ft section of 1" A-36 steel plate as the top, some 3x5" steel rectangular tubing as legs with 1/2"thick leg baseplates.
Cutting 4 legs from the 3x5 tubing using a Tannewitz TR3613 bandsaw with Lenox Diemaster II bimetal blade.

[Linked Image from kuhnbros.com]

So you can see the typical tubing rot that takes place on the inside of box and rectangular tubing..not bad in this case but Ive seen worse..Boat trailers are very susceptible to this.

[Linked Image from kuhnbros.com]

4 legs cut and ready for deburring and weld area bevel.

[Linked Image from kuhnbros.com]


More to come on this small but heavyweight project once I recover from Turkey/Deer/Cranberry/Stuffing/Gravy/Dessert Pie/Alcohol ingestion.
Happy Thanksgiving to all.