So on a Bobcat track skidsteer I just purchased, there are no provisions for rear tiedown of the machine..from everyone I talk to, they all say "just sling the chain up underneath the engine bay there's a slot"..well I being the guy I am wish a bit easier access for tiedown points..maybe its my military background,I like a solid tiedown..but the older models like mine didnt have much for tiedowns..and if you get the machine stuck in mud, there's no real place to get an attachment point for a recovery chain or strap..so after some planning and surveying of the machine, and far too many Twisted Teas, I designed two counterweights/securement points for it..here we go in the shop again fabbing it all up..simple in idea but complicated somewhat in execution due to unforseen factors.

Basically take two 12" x 24" x 1"thick steel plates, mount them with bolts to the sides of the skidsteer in the rear..this will give extra weight in the rear to offset a 72"mower that goes on the front.So I decided on 4- 1/2" Grade 8 bolts to hold each plate onto the machine with..photo drilling the holes in the first plate. I drilled almost thru with a 17/64 bit and then counterbored those holes with a 1"bit so the head of the bolt will sit below the surface of the plate,that way the second plate will sit flat on the first plate with the bolt location under the first plate. I found out the 12x24 plate is AR plate, has one very hard side to it,can't drill thru,drill went thru until about the last 1/4" and stopped cold..gonna have to blow that last bit out with the torch..no big deal..never know what you'll get when u buy plate at scrap yards.
[Linked Image from kuhnbros.com]

There's a second plate that will bolt to each 12x24 plate, the second plate is 12x12x1.5"thick..no real reason as to why I chose this plate, it was what I came upon first digging thru my pile of plate scraps,already cut to 12x12,that was a no-brainer..the second plate adds an extra 61lbs to the first plate for 142lbs each side..here we lay the second plate on top of the first and thru-drill bolt holes so everything lines up..so drilling thru 2.5"of steel with a 17/64 morse bit..this will be 5/8-11 tapped holes on the first plate..to be expanded on the second plate for pass-thru holes. I think I'll be able to tap the holes and not have to go deep enough to hit the hard side of the first steel plate.
[Linked Image from kuhnbros.com]
So I use a piece of 1/2" plywood down on the press table to drill thru to so as not to drill into the table..when U see wood chips its time to stop drilling.
And no the red tape was a stop for a previous drill job just never took it off.
Drill press is a 1960's Strands #3 morse gear drive press, 3phase 2hp with a 1to3ph VFD..great old drill pressowned/worked with it for over 35yrs.

more to come As I work on this amidst interruptions and MUD