Here is the homemade hydraulic tubing flaring tool that I made. I use this to made all the tubes on my loader. It will make 1/4 to 3/4 although I have only made 1/2" tubes.

If you choose to make one of these you are doing so at your own risk and assume the risk for any hydraulic tubes you choose to fabricate.


Attached Images
Push Clamp.pdf (81.68 KB, 1 downloads)
Flare Tool Base.pdf (58.79 KB, 1 downloads)
Flare Tool.pdf (39.68 KB, 1 downloads)
Top.pdf (29.36 KB, 1 downloads)
Side Clamp.pdf (25.52 KB, 1 downloads)
Flare Cup.pdf (14.91 KB, 0 downloads)
Bolt.pdf (8.92 KB, 1 downloads)
Last edited by GatorS; 03/25/2019 08:59 AM.
Machine Builders Facebook Page
https://www.facebook.com/groups/1153014311474457/

Report site issues on the FB page if you can't on the main site.